You achieve excellence by sweating the details, and that's why Dynamat offers
the 19100 license frame kit. It's designed to eliminate the most commonly
overlooked noise offender in your vehicle — the annoying rattle and buzz of a
naked license plate!
The kit contains everything you need to treat one license plate.
- license plate frame with Dynamat logo
- one 4"x10" piece of Dynamat Xtreme (to be applied to the back of
your plate)
- four pieces of foam gasket
Features
Overview: This kit consists of
a plastic license plate frame, a 4"x10" sheet of Dynamat Xtreme and 4
pieces of foam gasket material. The kit is made specifically to stop the
rattling noises caused by a vibrating license plate on a vehicle with a high
powered audio system.
Dynamat Xtreme: Dynamat Xtreme
provides 4 times the damping efficiency of Original Dynamat, the conforming
ability of Premium Dynamat, and the radiant energy reflection of Super Dynamat.
Dynamat Xtreme has an aluminum layer for high-temperature areas.
High Tack Permanent Adhesive: There
is a high tack permanent adhesive with a peel off plastic liner on the back of
the Dynamat Xtreme.
Installation
Installation Steps:
- Remove the license plate from
vehicle.
- Remove any dirt or grease from the
back of the plate.
- Firmly apply Dynamat to back of
plate. Press firmly to eliminate any air gaps.
- Apply the adhesive neoprene strips
to the backside of the Dynamat License Plate frame.
- Attach license plate into guides of
the License Plate frame, then install on vehicle.
Note: The package comes with
an "Installation Sheet" which actually has instructions for
installing Dynamat's Speaker Kit one one side and a listing of Dynamat's
specialty kits on the reverse side. The actual instructions for installing
the License Frame Kit are on the back of the package.
|
