Overview:

Looking for an amplifier to drive your subwoofers? You need to get your hands on the new GM-7300M Mono Amp. It powers out 360 watts when driven at 2 ohms - drive it hard, and you can even get up to 800 watts maximum. Plus, it delivers some important features for fine-tuning your system, namely selectable 50Hz bass boost and a built-in crossover. It also comes with oversized power terminals, speaker level inputs, and a wide input level of 400mV to 6.5V.

Highlights:

• 2-Ohm Mono Stable
  The GM-7300M is built to efficiently handle low-impedance loads, down to 2 ohms. Thats perfect for a pair of 2-ohm Woofers like the Pioneer TS-W307D2s, or a pair of 4-ohm Woofers like the TS-W307D4. And it doesnt just “handle” them: it continually monitors and adjusts the power supply voltage rails, for continuous, clean output.
  
• Variable Crossover LPF (40 ~ 240Hz)
  For added flexibility, the variable crossover lets you set the levels at which higher-frequency signals will be filtered out, so that the remaining lower-frequency signals get sent to your sub(s). Where they belong. This optimizes your systems efficiency and delivers the best possible sound quality. This step-up feature is a really useful tool for fine-tuning your system.
  
• Speaker Level Inputs
  What, you DONT own a Pioneer headunit? Well, we wont hold it against you. In fact well even help you build onto your system. The GM-7300Ms speaker level inputs allow you to connect your OEM unit (or any unit that doesnt have the typical RCA-type inputs) without having to buy add-on adapters. SO, the install goes faster, you save money, and youve got a Pioneer amp in your vehicle.
  
• Selectable Bass Boost
  Bass boost gives you more control over how your music sounds. Its set at 50Hz, ideal for tuning in some more thump from your subwoofers. And because this is selectable bass boost, you can set the level at 0dB, 6dB, or 12dB, whichever sounds best to you.
  

• Output Power (4 Ohm, <=1% THD): 250 Watts x 1
• Output Power (2 Ohm, <=1% THD): 360 Watts x 1
• Signal to Noise (1 Watt into 4 Ohms): 80dBA

• Peak Music Power: 800 Watts
• Number of Channels:  1
• Load Impedance Capability:  2~8 Ohm
• Continuous Power (4 ohm):  250W x 1
• Continuous Power (2 ohm):  360W x 1
• Frequency Response:  10Hz ~ 240Hz
• Total Harmonic Distortion:  0.03%
• Signal-to-Noise Ratio:  >100dB

• Channel # Capability:  1
• PWM Regulated MOSFET Power Supply
• Screw-Type Speaker Terminals
• Balanced Isolator Input Circuit
• RCA Inputs: 2 Channel
• Speaker Level Input:  2 Channel
• Input Level Control:  Hi-Volt (400mV ~ 6.5v)
• Built-in Crossover:  Variable LPF
• Crossover Frequency Range: 40~240Hz, -12dB/Oct.
• Bass Level Control:  50Hz, 0/6/9/12dB 

*Replacement for GM-7200M